Skip to content
Middletown, NY 10940 · Orange County

Stairs and landings in Middletown, NY

Exterior deck staircase and landings with white railings

A steady route from the deck to the yard

Stairs and landings need sound supports. Stringers are the sawtooth sides under the steps. Treads are the surfaces you step on; risers are the vertical faces between them. A soft stringer gets replaced, not covered with a new tread — a fresh tread screwed to a rotted stringer is how people find out the difference the hard way.

Uneven treads and a loose handrail make the whole deck hard to use. We check the stringers, the top connection, and the landing at the yard, then rebuild what is soft. We work across Middletown, Goshen, Warwick, Port Jervis, Chester, Monroe, and Montgomery. For a wobbly guard along the deck itself, see Railings. Free estimate or Call (845) 210-4477.

What stair work is — and what it is not

Stair and landing work means the stringers, treads, risers, handrails, and the base where the stairs meet the ground — measured as a system, because rise, the height of each step, and run, its depth, only feel right when every step matches. It is not just screwing down new boards: if the bottom step sits lower than the rest because the landing settled, the fix is at the footing, not the tread. And if the damage runs past the stair frame into the deck, that becomes deck repair on the same estimate, priced as its own line so you can see it.

When Orange County stairs need attention

Stairs fail faster than the deck they hang off, and local weather is why. Treads sit close to the ground where splashback keeps them damp; shaded backyards in Chester and Goshen never let that moisture dry. Freeze-thaw heaves the footings and landing slabs, and the bottom step ends up an inch lower than the rest — the trip point everyone in the family learns to remember. Snow gets shoveled onto the stair base and melts back into it all February. On split-levels and raised ranches around Middletown and Monroe the stairs are the most-used and least-inspected part of the deck, and on older builds the stringers were often plain lumber with no treatment where they meet the soil.

Wood deck stairs with a simple handrail leading up to a backyard deck

How the work runs

We measure rise and run on every step and check the stringers top to bottom, including the hangers at the deck and the base at grade. Soft stringers come out; sound ones stay. New treads go on with the fastening pattern the material calls for — some composite stair products want screws through the face even when the field boards use hidden clips. Landings get re-leveled on a solid base, and any new concrete gets cure time before the stairs carry weight. The stairs stay closed until the stringers, treads, handrails, and landings are secured, and we tell you the day you can use them again.

What is included, and what costs extra

  • Included: replacing soft stringers, treads, and risers; resetting the handrail; and re-securing the top connection, as listed on the estimate.
  • Often extra: rebuilding the landing frame or pouring a new footing where the base has settled or heaved, and widening a narrow stair run, which is a rebuild of the opening rather than a repair.
  • Separate service: replacing the deck guard or balusters beyond the stair rail — see railings.

What affects the cost

Step count and width set the material. Tread material sets the price too — cedar, pressure-treated pine, and composite treads land at different points, and some composite stair systems need closer stringer spacing, which adds labor. The big variables are hidden: what the stringers are fastened to at the top, and what the whole run sits on at the bottom. A heaved footing or a settled landing is concrete work, and we say so in the estimate before work starts. That is why we measure the full run on the visit instead of pricing stairs from a photo.

Questions homeowners ask about stairs and landings

Why does my bottom step sit lower than the rest?

The base under the last tread settled or heaved while the deck end stayed put. We check the footing and landing slab, re-set the base if it is sound, and rebuild it if it is not. Adjusting the tread alone just moves the trip to the next step up.

Can you rebuild stairs off an old deck?

Yes, if the frame where the stairs land is sound. We tie new stringers into the rim or a stair header, and we check the frame there before quoting — that connection carries every trip down to the grill.

Are closed risers required in New York?

Riser rules and the four-inch sphere rule for openings come from the building code, with the local building department holding the final say. We build to the code in force in your town and list the riser and spacing details in the written scope before work starts.

Recent stair work

“The bottom two steps had sunk so the first tread was more of a hop than a step. They re-set the landing on a proper base, replaced one stringer, and put cedar treads on the rest. Every step is the same height now — my mother-in-law noticed before I did.”

Priya S. · Chester · Stairs and landing rebuild

“Quoted the job from photos, then still came out to measure before ordering — which was right, because the run was steeper than it looked. Two days of work, stairs closed a third day for the footing, done. Straight talk the whole way.”

Ed J. · Warwick · Stringer and tread replacement

Let’s look at the job

Call with your town and a description of the work. Photos of the stairs and framing underneath help if you can take them safely. The written estimate sets out materials, scope, and scheduling.

Questions about deck stairs

Do I need a permit for new deck stairs in Middletown?

Permit requirements depend on the town and the scope of work. Confirm the requirements with the local building department before construction; discuss responsibility for permits when reviewing the estimate.

Why does my bottom step sit lower than the rest?

A settled base or ground movement can change the bottom step height. We check the base and footings before deciding whether the supports and stringers need rebuilding.

Can you replace just the stringers?

Yes. If the treads are still sound and only the stringers have rotted or split, we replace the stringers and keep the treads. If the treads have gone too, we price new treads at the same time.

Cedar or composite for the stairs?

Cedar treads need finish care. Capped composite treads have a plastic shell over a wood-plastic core; their required stringer spacing and fastening depend on the product. Hidden fasteners hold boards without exposed screw heads, but some stair products require screws through the tread. We follow the stair instructions and replace soft wood supports before installing either material.

How much does stair or landing replacement cost?

It depends on the number of steps, the material, and what the stringers and landing base are fastened to. New treads over sound stringers is a small job; replacing stringers, the landing frame, or a heaved footing costs more. We do not quote exact prices by phone — call (845) 210-4477 for a free written estimate after we measure the run and check underneath.

How long before I can walk the new stairs?

Keep the stairs closed until the stringers, treads, handrails, and landings are secured. New concrete supports may also need curing time. We tell you when the stairs can be used after checking the completed connections.

Do the stairs come with a new deck, or is that separate?

A new deck includes the stairs, rails, and landings on the plan. If you already have a deck and only the stairs need work, that is a smaller job we price on its own.

Can you replace just the treads?

When stringers are sound. Soft stringers get replaced too.

Call (845) 210-4477Free estimate